Thomashilfen Ronja Reha Bedienungsanleitung Seite 32

3. Installing your child seat (rearward facing) in
IMPORTANT - This child seat has been designed to perform safely and independently of further external restraint.
3a
3b
3c
3e
3
2
4
32
IMPORTANT - The child seat can be used with either a lap or a lap and
diagonal seat belt.
The child seat has an adjustable support leg
the more reclined the seat must be. The larger the child the more upright the
seat must be. To change the position (if required) pull the support leg clips off
of either side and slide the telescopic leg in or out
the position of the support leg, refit the clips in the holes (inset). Make sure the
hole positions chosen are the same on both sides.
Place the child seat rearward facing with the back of the child seat positioned
centrally between the driver and passenger seat.
Extend the footprop fully and make sure that the footprop tether brackets are
facing forwards and that the straps are not twisted. Lower the footprop and
adjust the height so that it is within approximately 30mm of the floor
(dia 3b). Use the ruler printed on the back page of this manual to get the
correct distance from the footprop to the floor.
3d
Slide the loop ends of the tether straps between the front car seat and back
as shown (dia 3e). Bring the buckle ends of the tether straps around the
outside of the car seat and feed through the loops
tether straps onto the tongues on the sides of the child seat
tighten the tether straps by pulling the loose ends downwards
rear middle seat
(dia 3a). The smaller the child
(dia 3a). Once satisfied with
Loop a tether strap around both the
front driver and passenger seat as
shown (dia 3c).
If your car is equipped with a runner
loop on the seat runners, these may be
used as an alternative (see detail
IMPORTANT - Do not install the tether
straps using the Luggage loops
2 . Snap the buckles of the
. Provisionally
3
4
3d).
.