Thomashilfen Ronja Reha Bedienungsanleitung Seite 31

2f
2g
2h
2j
If your car is equipped with a runner loop on the seat runners, these may be
used as an alternative (see detail
IMPORTANT - Do not install the tether straps using the Luggage loops.
Pull off sufficient lap and diagonal belt (approx.600-900mm). Open the lock-off
arm on the side opposite the seat belt buckle. Pull back the child seat cover to
reveal the crotch strap. Feed the belt through the lock-off belt guide and seat
shell slot (dia 2g), up on to the top face of the seat base, behind the crotch
strap (inset) and down through the slot on the other side of the child seat.
Open the other lock-off arm, feed the seat belt under the lock-off arm and
attach the tongue into the buckle
2i
2k
2f).
(dia 2h).
Pull all of the seat belt slack through the
child seat ensuring the seat belt is not
twisted (dia 2i). When the belt is as tight
as possible, close the lock-off arms on
BOTH sides of the seat ensuring that they
click into place.
If the buckle now lies in the position
marked as wrong with a
belt cannot be correctly tightened
try another seating position in the car.
Finally tighten the tether straps by pulling
the loose ends downwards
until the footprop touches the floor. The
footprop must rest on a solid floor - not on
lids of storage boxes or similar.
Once firmly strapped in, test the child seat
by trying to move it back and forth and
side to side. If it seems loose, you must
re-install until firmly installed.
DO NOT rest the back of the child seat
against the driver or front passenger
seats.
0 - 25 kg
and the seat
(dia 2j),
(dia 2k)
31