Herunterladen Diese Seite drucken

Thomashilfen Ronja Reha Bedienungsanleitung Seite 28

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. Adjusting the child seat to suit the weight of your child
IMPORTANT - This child seat has been designed to perform safely and independently of further external restraint.
1a
1b
0 - 25 kg
1c
1d
28
Adjusting the Harness
Press in and hold the harness release button and with your hands below the
chest pads
(dia 1a)
pull
Unfasten the buckle by pressing the red harness buckle button. Fit the harness
around your child. To fasten the buckle; first fit the two upper sections together
(inset), then push them firmly into the lower section until you hear a positive
click. Gently pull the harness up to tighten the lap sections to fit. Pull the
adjuster strap forward making sure the harness is a comfortable but
around your child. Make sure the harness straps are not twisted.
IMPORTANT
- You must adjust the height of the shoulder straps to the correct
position for your child
BEFORE
pads must sit high on the child's shoulders as shown
The shoulder straps
MUST
nearest the top of your child's shoulders. If in any doubt use the slot just below
the shoulder rather than above it
Once you reach the top slots your child may continue to use the seat until their
eye line is above the top of the seat shell.
Changing the height of the shoulder straps
To loosen the harness, press in and hold the harness release button and with
your hand below the chest pads
as far as they will go. Pull the yoke out from behind the seat and unhook one
shoulder strap
(dia
1c). Pull the cover from the top of the seat so that you can
see the slots in the seat shell. Pull the shoulder strap through to the front of the
seat.
Pass the shoulder strap though the chosen slot and hook the shoulder strap
back onto the yoke
(dia
Make sure that the straps are not twisted.
BOTH
shoulder straps forward as far as they will go.
installing the child seat in a car. The chest
be threaded through the slots in the cover and shell
(dia
1b).
(dia 1a)
pull
BOTH
1d). Repeat with the other shoulder strap.
FIRM
fit
(dia
1b).
shoulder straps forwards

Werbung

loading