R&G RSET32 Montageanleitung Seite 7

Page 7 of 21
• Remove the bolt holding the banjo fitting to the top of the master cylinder and replace the bolt with the new
brake light sensor switch (item 6) using the sealing washers supplied (item 7), as shown in picture 18.
PLEASE NOTE THAT THE BRAKING SYTEM WILL NOW REQUIRE BLEEDING.
• We recommend cutting the original wiring and using the bullet connectors (item 8) to connect the brake light
sensor switch wiring to the original wiring, demonstrated in picture 19.
BRAKES AND BRAKE LIGHT BEFORE RIDING.
Due to the complexity and inherent dangers involved in undertaking any work involving the braking
system, we strongly recommend a qualified mechanic either fits or checks the fitting of this product.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do
not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no
representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation
and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the
Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has
been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return
of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products
have been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice
or if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and
personal injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer
for the Products or the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable
condition, in the opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the
prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless within 14
days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Tel: +44 (0) 420 89007 Fax: +44 (0)
1
Picture 18
ISSUE 3
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Unit , Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 8730
1
05/07/2021 (DM)
CONSUMER NOTICE
R&G
www.rg-racing.com
1
Picture 19
PLEASE CHECK OPERATION OF
Email: info@rg-racing.com
RSET32