Wiring According To Emc Requirements - Lenze 8200 motec Montageanleitung

Show/Hide Bookmarks
Conditions for trouble-free operation:
Except for the mains cable, use shielded cables only.
l
The shield must be carefully connected to PE.
l
Connect motor and mains PE conductors to separate PE terminals.
l
A
D D
Abb. 1-20
0
Mains cable L1, L2, L3, PE
1
PE connection - mains cable
2
PE connection - motor
3
Shielded control cable
4
Shield connection for control cable (screw shield to shield sheet)
5
PE connection - terminal strip X2
6
Isolated terminal (e.g. star point for motor star connection)
7
Function module
X1 Terminal strip - mains connection
X2 Terminal strip - motor connection
PES HF shield connection by connecting the shield with a surface as large as possible to PE
L

Wiring according to EMC requirements

B
C C
I I
EDK82MV222 DE/EN/FR 3.0
X1
X2
H
Motor mounting
Shield connection
1. Prepare cable
F 2. Route the cable
through the eyebolt
of the shield and
bend the eyebolt.
G G
3. Tighten the screw.
The shield must be
tightly connected to
the shield sheet.
PES
8200mot101
3
0.7 Nm
6 lb-in
21