Messages; Disturbances / Fault Messages; Status Message; Cyclic Message ["Alive" Message] - Condor Sim800F Betriebs Und Installationsanleitung

_________________________________________________________________________________
11.

Messages

11.1

Disturbances / fault messages

In case of a fault in the electric control unit or the pump(s), the data shown below is signalled. This
message must be acknowledged by the recipient.
Also refer to Sections 9.2.4 and 10.2.
11.2

Status message

It is possible to receive a status message from the control unit.
To do this, simply send an empty SMS message to the modem.
To prevent unauthorised access to the modem, the software compares the phone numbers of
incoming calls with the numbers stored in the "Target 1 – 4" menu.
11.3

Cyclic message ["Alive" message]

If the "Cyclic message" function has been activated in Section 10.6, the message shown below is sent
to the stored target phone numbers by the modem.
Operating and installation manual for GSM mode
 Station name
 Filling level / status of float switch

Present status of control unit [SYS]

Present status of pump(s) [P1/P2...]

Pending fault(s) [P2 motor protection]
 Station name
 Filling level / status of float switch

Operating status of pump(s)
[Manual – Off – Automatic]

Operating hours of pump(s)

With prepaid SIM cards, the balance and the
expiry date [see Section 10.7]
 Station name
 Filling level / status of float switch

Signal strength of GSM network

With prepaid SIM cards, the balance
and the expiry date [see Section 10.7]
Page 24
903 501 - V1.0