Condor SIM800F Betriebs Und Installationsanleitung Seite 37

_________________________________________________________________________________
 To prevent inadvertent disconnection of the MMCX plug, the antenna cable must be secured
to the CPU socket with a cable tie and adhesive base (Fig. 10).
Fig. 10
Remove the upper knock-out (12 mm) on the bottom of the control unit housing. This can be

done by lightly hammering against the knock-out with a suitable screwdriver from inside the
housing (Fig. 11).
Pass the cable end with the silver FME socket through the opening and secure it from outside

with the M14 locknut (Fig. 12).
Run the antenna cable inside the housing so that it does not come into
contact with live components. Also make sure that the cable cannot break or
become damaged if the CPU circuit board must be removed at a later time.
Reassemble the CPU circuit board and the master switch knob in the reverse order as

described in the first section.
Replace and secure the terminal compartment cover.

Fig. 11
Operating and installation manual for GSM mode
Fig. 12
Page 8
903 501 - V1.0