Meec tools 014167 Bedienungsanleitung Seite 45

2. Release the parts of the spray gun from
each by pressing down the lock button (6).
FIG. 3
4. Unscrew the container and pour residual
material back into the original container.
5. Clean the container and suction hose with
a brush. Pour solvent into the container
and put it back on the spray gun. Do not
use solvent that has a flash point lass than
21°C.
6. Put the spray gun together again.
7. Plug in the plug, start the product and
spray the solvent into a container or on
a rag.
8. Repeat until only clean solvent comes out.
9. Switch off the product and pull out the
plug.
10. Clean the spray gun and container with a
cloth moistened with solvent.
11. Unscrew the lock ring and remove the air
nozzle and nozzle. Clean with solvent and
a brush.
WARNING!
Never immerse the back part of the product
in water or any other liquid. Clean the casing
with a damp cloth.
IMPORTANT:
• Never run the product without an air
filter – risk of material damage.
• Never clean the nozzle and air holes on
the spray gun with sharp metal objects.
The ventilation hose and diaphragm
have a limited resistance to solvent.
Wipe them with a cloth moistened with
solvent, but do not immerse them in
solvent.
• The ventilation hose and diaphragm
have a limited resistance to solvent.
Wipe them with a cloth moistened with
solvent, but do not immerse them in
solvent.
REPLACING THE AIR FILTER
Replace the air filter when necessary. Release
the cover on the compressor unit and put the
new air filter in the cover. Press the cover in
place again.
FIG. 12
WARNING!
Never run the product without an air filter –
risk of material damage when adjusting the
air flow.
EN
45