Chassis - Yamaha WR250F Fahrer- Und Wartungshandbuch

Ê Fasten the diode and rectifier/regulator lead, with the diode at
its white tape and the rectifier/regulator lead at its protecting
tube.
Ë Fasten the wire harness, starter motor lead and negative bat-
tery lead so that the plastic locking tie ends do not contact the
ignition coil lead.
Ì Fasten the wire harness, rectifier/regulator lead, coolant reser-
voir hose, hot starter cable, negative battery lead and starter
motor lead.
Í Fasten the wire harness, negative battery lead, starter motor
lead, rectifier/regulator lead and coolant reservoir hose at the
white tape for the negative battery lead.
Î Fasten the wire harness at its white tape.
CABLE ROUTING DIAGRAM
Ï Fasten the wire harness, throttle position sensor lead (in the
wire harness), starter motor lead and negative battery lead.
Ð Make sure that the throttle position sensor coupler does not go
outside the chassis.
Ñ Fasten the throttle position sensor lead.
Ò Pass the carburetor breather hoses, carburetor overflow hose
and coolant reservoir breather hose between the connecting
rod and cross tube (frame).
Ó Fasten the neutral switch lead and oil hose together with the
plastic locking ties and cut off the tie ends.
Ô Pass the cylinder head breather hose through the hose guide.
Õ Fasten the neutral switch lead.
2 - 99
SPEC