Maintenance; Storage - Parkside Pas D7 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Ensure the cutting blade
o
tight in the slot of the spindle
(Fig. L).
Tighten the scre
o
direction.
The attachment is ready for use
o
again.
NOTE: Replacement cutting
blades are available from OWIM.
[ ]
˜ S
S
On
O
NOTE: You can use the LED work
light e ven when the product is
8 ] [
not in use. Set the rotation direction
s itch to the middle position.
[ 5 ]
S itch the LED or light on/o
according to above description.
˜ Cleaning and maintenance
Before cleaning or carrying out any
o

maintenance:

Set the rotation direction s itch
–
to the middle position. This
prevents unintentional switching
on.
Remove the USB cable
–
Remove the bit
–
bit holder
[ ]
attachments
Disconnect the charger
–
the socket-outlet.
Never allo fluids to get into the
o
product.
76 GB/MT
is sitting
[ ]
[ ]
in a clockwise
[ ]
Action
Press the switch
trigger and hold
7 ] [
it in place.
The LED work
light lights up.
8 ] [
Release the switch
trigger .
7 ] [
The LED work
light goes o .
8 ] [
.
[ ]
, the magnetic
[ ]
or any of the
.
[ ] [ ] [ ] [ ]
from
[ ]
The product must always be kept
o
clean, dry and free from oil or grease.
Remove debris from it after each use
and before storage.
Regular and proper cleaning will help
o
ensure safe use and prolong the life
of the product.
Clean the product with a dry cloth.
o
Use a soft brush for areas that are
hard to reach.
In particular clean the air vents
o
after every use with a cloth and soft
brush.
The vents must always be clear.
o
NOTE
Do not use chemical, alkaline,
u
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces.
˜ Maintenance
Before and after each use: Check
o
the product and the following
accessories for wear and damage:
Magnetic bit holder
–
[ ]
Screw bits
–
[ ]
Torque attachment
–
[ ]
Eccentric attachment
–
[ ]
Angle attachment
–
[ ]
Cutting attachment
–
[ ]
If required, exchange the accessories
for new ones:
[ 5 ]
see "Changing bits and magnetic
–
bit holder"
see "Replacing the cutting blade"
–
Observe the technical requirements
of the accessories (see "Technical
data").
˜ Storage
Set the rotation direction s itch
o
to the middle position. This prevents
unintentional switching on.
5 ] [