HMS ABS MASTER PRO Gebrauchsanweisung Seite 6

5. Removing the device
• Ensure that the device is switched off, then gently remove it.
• Try not to touch the gel with your fingers.
• Put on the protective film and place the device in its case. If the pads are dirty, replace them.
• If any traces of gel remain on the skin, wash them off with soap and water. Leaving the gel on the skin for too long may cause irritation.
Exercise level chart
Level
Warm-up
Intense, combined
Intensive, combined
Stepped
Stepping
Maintenance and storage
1. After completing your workout, place the device on the protective film.
Do not bend the gel pads or stick them together.
o
Do not press the pads firmly against the protective film.
o
Do not bend the protective film.
o
2. Put the device in the case after finishing your workout.
Ensure that the protective film and case are clean.
o
Avoid high temperatures.
o
Use the device only for its intended purpose.
o
Keep the device away from fire.
o
If the device is not used for a long period of time (approx. 1 month), remove the batteries.
o
Disposal
Dispose of the device in accordance with local regulations. In case of prolonged use, replace and dispose of worn or damaged parts.
Cleaning and maintenance
•
Ensure that the device is switched off before cleaning.
•
Do not wash the device with water.
•
Do not use chemical cleaning agents.
•
Wash your hands before touching the gel pads.
•
Use a slightly damp cloth for cleaning to avoid damage.
•
For heavy soiling, use a damp cloth with a mild cleaning agent.
•
After cleaning, store the device in a cool, dry place.
•
If the gel is dirty, it will be more difficult to stick it to the skin. In this case:
o Apply a few drops of water to your finger and spread it over the gel pad.
Leave the mat to dry in a cool, dry place, with the gel facing upwards.
o
Once dry, apply the protective film.
o
•
Do not clean the gel for too long – this may shorten its lifespan.
Possible problems and solutions
Problem
The device does not switch off
I cannot feel the pulse
The pulse is too weak
The pulse is too strong
The device suddenly stops
working
The device does not adhere to the
body
Skin becomes red and irritated
Additional tips
• If the above solutions do not work, ensure that the battery is properly connected and press down on the protective cover.
• The gel wears out during exercise – purchase a new pad if necessary.
• If you continue to experience problems with the device, discontinue use and contact your distributor.
Mode Time (minutes)
M1
M2 & M3
M4
M5
M6
Cause
No batteries
Battery not installed correctly
Battery is flat
Incorrect battery type
The gel does not adhere to the skin
Gel pad damaged
Gel pad is dirty
Intensity level is too low
Low battery level
Gel pad damaged
Gel pad is dirty
Intensity level is too high
The gel does not adhere to the skin
The battery is flat
The gel pad is dirty
The gel pad is damaged
Gel pad is not properly attached
Gel pad is dry or dirty
The gel pad is damaged
Intensity
15 low
15 high
15 medium
15 high
15 medium
Insert the battery
Place the battery with the "+" terminal facing upwards
Replace the battery
Use a CR2032 battery
Ensure there is no gap between the gel and the skin
Replace the pad
Clean the pad
Increase the pulse intensity
Replace the battery
Replace the pad
Clean the pad
Reduce the pulse intensity
Ensure there is no gap between the gel and the skin
Replace the battery
Clean the pad
Replace the pad
Ensure that the gel adheres completely to the skin
Clean the pad
Replace the pad
6
Session
1
3
2
3
2
Solution
EN