BURG WÄCHTER secuENTRY easy PINCODE Montageanleitungen Seite 36

• To close the battery compartment, first press the battery compartment lid
close to the screw holes to make them slide into the recesses, then snap
the bottom side into position by pressing on it.
• Fasten the battery compartment lid with screws
Attention! Make sure that no moisture enters the keypad when
replacing the battery.
Cleaning instruction secuENTRY easy keypad
The surface finish of the keypad prevents adherence of impurities. Dust or
dirt can be removed from the surfaces using a damp cloth.
No alcohol-based detergents (spirit, SIDOLIN
detergents (acetone etc.) may be used, as they can damage the
surface or the sensor.
Replacement of batteries – knob (inner side)
1 Using the attached hex key, loose the top locking screw on
the cylinder cover. It can be turned out only up to the opening of
the cover and will not fall out.
2 Open the cover
3 Replace the batteries. Make sure the batteries are inserted with the correct
polarity, indicated at the marked point on the housing.
38 | English
etc.) or aggressive
®
secuENTRY easy
4
E
Us
fai
1
2
3
Tu
loc