BURG WÄCHTER secuENTRY easy PINCODE Montageanleitungen Seite 35

Attention! Do not use more liquid than absolutely necessary.
• Slide the keypad in from above until the
locking peg of the mounting plate engages
into the keypad housing. In this way, the
keypad is protected against undesired removal.
• Perform a function test of the unit with the
door open. For this purpose, enter repeatedly
a valid opening code (e. g. PIN code,
fingerprint, ...).
Battery replacement for the secuENTRY easy keypad
• Remove the housing cover on the bottom side by loosing
the 2 screws (Tx 8).
• Pull the battery compartment lid downwards until it disengages and
replace the batteries.
When inserting the new batteries, be careful to observe
the correct polarity as indicated on the housing.
sy secuENTRY easy English | 37