Makita 4131 Betriebsanleitung Seite 9

ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use
of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Rip fence (Guide rule)
• Safety goggle
• Recommended Carbide-tipped saw blades & workpiece ranges
Carbide-Tipped Metal Blades for Many Applications
METAL SHEET
Size (mm) t=1.5 t=3.0
185x36T
185x38T
185x48T
185x70T
CAUTION:
• Always use carbide-tipped saw blades appropriate for your job. Do not cut aluminum, wood, plastics, concrete, tiles,
etc.
• Carbide-tipped saw blades for metal cutting saw are not to be resharpened.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (
Sound power level (
Uncertainty (K): 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: cutting steel pipe
Vibration emission (a
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been mea-
sured in accordance with the standard test method and
may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the oper-
ator that are based on an estimation of exposure in the
actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to
the trigger time).
C-STUD ANGLE-STUD
50x100 45x90 50x50
t=1.6 t=3.2 t=4
): 99 dB (A)
L
pA
): 110 dB (A)
L
WA
2
): 2.5 m/s or less
h
2
Applications
METAL STUD
50x50 t=0.56 t=1.6
t=6 25Ga 16Ga
Excellent
ENG102-3
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible manufac-
turer declare that the following Makita machine(s):
Designation of Machine: Metal Cutter
Model No./ Type: 4131
ENG241-1
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
ENG901-1
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, MK15 8JD, England
REBAR PIPE
∅25 ∅60
50x100
∅20
t=3.2 t=1.2 t=3.8
Good Fair
30th January 2009
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, JAPAN
CORRUGATED
SHEET
t=1.0-
t=0-0.9
2.0
Not Applicable
ENH101-13
9