Pairing With The Boneco H400 Smart; First Pairing; Wifi Reset - Boneco H400 Smart Anleitung

44

PAIRING WITH THE BONECO H400 SMART

en

FIRST PAIRING

To pair the SMART device with the SMART App for the
first time, please follow these steps:
1. Make sure that your smartphone is connected
to the WiFi network where the device is being
set up.
2. Make sure that Bluetooth® is activated on your
smartphone.
3. During pairing, make sure that the smartphone
is in the same room as the BONECO SMART Appli-
ance.
4. Switch on the BONECO SMART Appliance.
5. The device enters pairing mode automatically
upon startup if it hasn't been connected to a WiFi
network before. Pairing mode is indicated by the
flashing status LED.
6. Start the BONECO SMART App.
7. Add the device in the SMART App.
After a successful pairing, you can control the
BONECO SMART Appliance from anywhere using your
smartphone with a mobile internet connection.

WIFI RESET

To reset the connection to an existing WiFi network
and connect to a new WiFi network, please follow
these steps:
1. Make sure that your smartphone is connected
to the WiFi network where the device is being
set up.
2. Make sure that Bluetooth® is activated on your
smartphone.
3. During pairing, make sure that the smartphone
is in the same room as the BONECO SMART Appli-
ance.
4. Switch on the BONECO SMART Appliance.
5. Press and hold the knob on the front for about
5 seconds until all LEDs flash pink and then re-
lease the knob.
6. The device now switches off. Switch the device on
again and the flashing status LED indicates that
the device is now in pairing mode.
7. Start the BONECO SMART App.
8. Add the device in the BONECO SMART App.