Dometic B1600 PLUS Montageanleitung Seite 36

Installation
12 Vgcable
You can connect the lighting to the battery. This enables you to switch on the
lighting even if the 230 Vwvoltage supply is not connected.
To do this, proceed as follows:
➤ Disconnect the 2-pin plug (3) from the socket on the main board.
➤ Connect the positive cable (4) with the plug.
➤ Connect the negative cable (5) with the plug.
Connecting the circuit board
See fig. e
➤ Insert the 12-pin plug (1) in the socket (4) on the circuit board of the air
outlet unit.
➤ Insert the two 2-pin plugs (2) in the sockets (3) on the circuit board.
8.6 Installing the air outlet unit
See fig. f
➤ Attach the air outlet unit to the (1) fastening brackets using the short
fastening screws.
See fig. g
➤ Install the air filter in the specified sequence.
See fig. h
➤ Fit the filter covers.
34
B1600PLUS, B2200, B2600
EN