Technical Data; Before Commissioning; Installation Instructions; Installation And Setting - Scheppach Tiger 2500 Original Bedienungsanleitung

Residual risks
m The machine has been built according to the state-
of-the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Danger of injury for fingers and hands due to the ro-
tating grinding disc.
• Hazard due to electrical power with the use of im-
proper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety in-
structions" and the "Proper use" are observed along
with the whole of the operating instructions.
7.

Technical data

Dimensions L x W x H
Tool support ø
Grindstone
Grindstone idle speed
Cutting speed
Weight approx.
Engine
Power
Motor speed
Operating mode
Subject to technical changes!
Noise
The noise levels have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA

8. Before commissioning

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
320 x 325 x 335 mm
12 mm
ø 250/12 x 50 mm
90 rpm
1.2 m/s
16 kg
230 – 240 V~ / 50 Hz
200 W
1400 rpm
S1 100%
71.8 dB
3 dB
84.8 dB
3 dB
www.scheppach.com
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
ATTENTION!
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
Before connecting the machine to the mains power,
make certain that the data on the type plate matches
with the mains power data.
m Warning!
Always ensure that the machine is switched off and dis-
connected from the power supply before changing the
device settings.
• All covers and safety devices must be properly fitted
before switching on the device.
• The grindstone must be able to run freely.
• Before operating the on/off switch, make sure that
the grindstone and honing wheel are correctly
mounted and that the moving parts of the device
function smoothly. Visually inspect both for defects.
• Replace a damaged or worn grindstone.
9.

Installation instructions

m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
9.1

Installation and setting

Please make sure that your grinding machine stands
upright and stable on a solid surface with sufficient
lighting.
The machine has no front or rear side. Grinding can take
place either with or against the direction of rotation.
The grindstone is not pre-assembled for packaging
reasons.
m Warning!
Do not connect the device to the power supply until
assembly is complete. Failure to do so may result in
accidental starting and possibly serious injury.
GB | 25