Use With An External Dmx Controller - Renkforce DL-1115 Bedienungsanleitung

Display Option
Addr 001-512
UEr Ur01
SoUn on
oFF
Led on
oFF
SLNd NASt
SL 1
SL 2
ShNd SP01
SP02
SP03
SP04
SP05
SP06
dISP dISP
dSIP
ChNd 1Ch
7Ch
b) Use with an External DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 1 or 7 free DMX channels.
Setting the DMX operating mode
• Push the button FUNC (5) until "ChNd" is displayed and push the button ENTER (8).
• Select the desired operating mode with the UP (7) and DOWN (6) buttons:
1Ch 1-channel DMX operation
7Ch 7-channel DMX operation
• Push the ENTER button (8) to confirm your selection.
Function
Setting the DMX starting address
Display of the software version
Sound-to-light mode activated
Sound-to-light mode deactivated
Display permanently on
Display switches on only after operation of
the FUNC (5) button
Operation as a master device
Operation as a slave device
Operation as a slave device
All automatic effects alternatingly
Automatic effect 1
Automatic effect 2
Automatic effect 3
Automatic effect 4
Automatic effect 5
Display aligned normally
Display alignment turned by 180°
1-channel DMX operation
7-channel DMX operation
Comment
normal slave mode
inverted slave mode
when the device is installed
turned by 180°
31