HOMCOM JT62115 Bedienungsanleitung Seite 4

EN
5.Insulation mode: when this appliance comes into the selected temperature, if press the
insulation button, then this appliance comes into insulation, can also press insulation
button, exit insulation. When heating to the selected temperature, this appliance stops
heating into insulation state. During heating process, you can also choose the insulation
temperature and press the insulation button at any time, but above 90 ° C can't choose
the insulation mode. In the insulation state, the ° C lamp flickers. If the ° C lamp does not
flicker, the product is not in the insulation mode.
6. When this appliance works, the display screen dynamically displays the actual water
temperature. During the heating process, you can press the power button at any time to
cancel the heating state.
7. Only display the insulation temperature. When the water temperature is below 5 ° C to the
insulation temperature, this appliance turns on heating and repeats the cycle. When you
press the power button in the insulation state, this appliance returns to the standby state.
8. The holding time is set to 3 hours, if there is no follow-up operation, then automatically
return to standby after 3 hours.
9. Memory mode: under working state, if the pot leaves the base, the digital tube shows 00.
If the pot is put back to the base within 300 seconds, then this appliance continues to
work as before. If the pot is put back to the base more than 300 seconds, then this
appliance comes into standby state, show actual water temperature.
Display Error Code (open-circuit or short-circuit)
The two horizontal lights in the middle indicate
that the sensor is open-circuit.
The two horizontal lights in the bottom indicate
that the sensor is short-circuit.
4