HOMCOM JT62115 Bedienungsanleitung Seite 3

EN
Never reach for the appliance if it falls into water. Immediately remove the plug from
•
the wall socket - do not use the appliance again.
Only use the base supplied with the kettle. Never use the base for other purposes.
•
Remove the kettle from the base, then fill with water from the tap. Never fill the kettle
•
above the 'max' level.
Only switch on the appliance after it has been filled with water. Only use cold water to
•
fill.
Whilst the appliance is in use, ensure the lid is securely closed.
•
Never open the lid when the water is still boiling.
•
Only water must be used in this appliance- do not use for other liquids.
•
Fill the kettle with at least 0,75 litres of water.
•
Before storing the appliance, allow it to cool to room temperature.
•
Never use the appliance through an external timer or remote control.
•
OPERATION
This appliance is for domestic use only. It is not intended for commercial use.
Feture
1. Top lid
2. Spout
3. Body
4. Base
5. Insulation button
6. Reduce the temperature
7. Increase the temperature
8. Power button
Operation Instructions
1. This appliance is with 4 settings, insulation button, temperature selection buttons "+", "-"
and power button.
2. After electrifying, the buzzer beeps with a short sound. While the LED lamp flashes for 0.5
seconds. This appliance is in standby state, showing the actual water temperature.
3. Press the power button, the display shows 100 ° C. If no follow-up operation, this
machine will come into the heating state after 3 seconds, until water boils. After boiling for
5 seconds, the buzzer beeps twice and stops heating, this appliance is in standby state,
showing the actual water temperature.
4. Temperature selection mode: if you press "+" or "-" button, the temperature rises from 40
degrees, increase the appliance to 5 degrees, that is, every time you press "+", the
temperature value increases 5 degrees, press"-", the temperature value reduces 5
degrees. After the temperature selected, you need to press the power button or the
insulation button to heat.
3