Herunterladen Inhalt Inhalt Diese Seite drucken

K) Stopping The Vehicle - Reely NEW1 RtR Bedienungsanleitung

1:10 elektro-monstertruck
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Stop driving immediately if the vehicle shows any unusual responses to the remote commands or if the
vehicle does not respond at all. This behaviour could be caused by low drive batteries, low batteries/
rechargeable batteries in the remote control or by too great a distance between vehicle and remote control.
A coiled telescopic receiver aerial, interferences on the radio channel used (e.g. radio transmissions from
other devices, Bluetooth
responses of the vehicle.
Since the receiver is supplied with power via the speed controller/drive battery, low or empty drive batteries
will cause unintentional movement of the vehicle (e.g. twitching of the steering servo, etc.).
For example, the voltage of the drive battery decreases for a short time under full throttle, so that the
receiver will no longer receive the required operating voltage. The vehicle will speed up, but the steering
servo does not react properly. Stop operating the vehicle at once and use a new, fully charged drive battery.
When the drive battery is flat, wait for at least 5 - 10 minutes until motor and speed controller have cooled
down sufficiently before the next run. Only then start a new drive with a full drive battery.

k) Stopping the Vehicle

To stop driving, proceed as follows:
• Let go of the throttle/brake lever on the transmitter so that it goes into neutral position, and let the vehicle run out.
• After the vehicle has stopped, the speed controllers switch off (switch position "OFF").
Never touch the wheels or the drive mechanism, and make sure you do not move the throttle/brake lever
at the transmitter! Do not hold the vehicle at its wheels!
Attention!
The motor, the speed controller and the drive battery get hot during operation! Do not touch these parts
immediately after operation. Danger of burns!
• Disconnect the drive battery from the speed controller. Disconnect the plug-in connection completely.
• Now you may turn off the transmitter.
42
, WLAN) or adverse transmission/reception conditions may also cause unusual
®

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

15599751551069

Inhaltsverzeichnis