G) Connecting The Drive Battery To The Speed Controller; H) Switching On The Speed Controller; I) Attaching And Fastening The Car Body - Reely NEW1 RtR Bedienungsanleitung

g) Connecting the Drive Battery to the Speed Controller

To prevent sudden start-up of the wheels and
therefore uncontrolled starting of the model
(e.g. if the trimming for the drive is malad-
justed), place the model vehicle on a suitable
support (or starting box), so that the wheels can
turn freely in case of an error.
Do not reach into the drive. Do not hold the
wheels.
Switch off the speed controller first (switch position "OFF").
The on/off switch is at the top of the chassis, right next to
the steering servo. Then switch on the transmitter if you
haven't done so yet (see chapter 9. d) and e)).
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable = mi-
nus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Important!
This vehicle is suitable only for use with a LiPo drive battery with 2 cells (nominal voltage of drive battery
7.4 V) or NiMH drive battery with 6 or 7 cells (nominal voltage 7.2 V or 8.4 V).
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.

h) Switching on the Speed Controller

Switch on the speed controller by moving the slider (see figure in chapter 9. g) into the "ON" position. Then wait for
a few seconds (leave the throttle/brake lever on the transmitter in the neutral position; do not move it) until the speed
controller has completed its self-test.
When the speed controller has not recognised any transmitter signal or correct neutral position, the red
LED will continue to flash. The speed controller cannot be taken into operation.
Sound signal meanings
• 1x short sound: NiMH/NiCd drive battery recognised
• 2x short sound: 2-cell LiPo drive battery recognised
• 1x long sound: Self-test complete, throttle/break le-
ver at the transmitter is in the neutral position, speed
controller is ready
The sounds are generated by a short start-up of the motor.
Now check the drive and steering functions of the vehicle.

i) Attaching and Fastening the Car Body

Put the car body onto the supports and secure them each with the safety clips.
40
LED status
• LED off: Throttle/brake lever at the transmitter is in
the neutral position
• LED flashes: Throttle/brake lever at the transmitter is
in the position for forward or reverse driving
• The LED is lit: Full throttle forwards