J) Controlling The Vehicle - Reely NEW1 RtR Bedienungsanleitung

j) Controlling the Vehicle

Put the ready-to-run vehicle on the ground. Do not reach into the drive, and to not hold the vehicle at its rims.
Operate the throttle/braking lever for the drive function at the transmitter very cautiously and do not drive
too quickly at the beginning until you get used to the car's reactions. Do not make any quick and jerky
movements with the operating elements of the remote control.
If the vehicle tends to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in the neutral position briefly
(approx. 1 second) (neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward
to reverse directly, the brake function of the drive is activated (vehicle will NOT reverse).
The following figures are only to illustrate the functions and do not necessarily correspond to the design of
the transmitter provided.
1. Let go of throttle/brake lever (neutral position); the vehicle rolls to a halt or does not move anymore (if necessary,
adjust the trim control for the driving function at the transmitter)
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Going forwards and then going in reverse (wait briefly between changes and leave the lever in its neutral position!)
Wait briefly
41