Parkside Performance PPTLBA 40-Li C3 Originalbetriebsanleitung Seite 8

Do not abuse the cord. Never use the
cord for carrying, pulling or unplug-
ging the power tool. Keep cord away
from heat, oil, sharp edges or moving
parts. Damaged or entangled cords in-
crease the risk of electric shock.
When working outdoors with an
electrical power tool, always use ex-
tension cords that are also suitable
for outdoor use. Use of a cord suitable
for outdoor use reduces the risk of elec-
tric shock.
If operating a power tool in a damp
location is unavoidable, use a power
supply protected by a residual current
device (RCD). Use of an RCD reduces
the risk of electric shock.
3. Personal safety
Stay alert, watch what you are doing
and use common sense when operat-
ing a power tool. Do not use a power
tool while you are tired or under the
cation. A moment of inattention while
operating a power tool may result in se-
Use
Always wear safety goggles. Protective
equipment such as a dust mask, non-
skid safety shoes, hard hat or hearing
protection used for appropriate condi-
Prevent unintentional starting. Ensure
connecting to power source and/or
battery pack, picking up or carrying
the tool.
the switch or energising power tools that
have the switch on invites accidents.
Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a rotat-
ing part of the power tool may result in
Do not overreach. Keep proper foot-
ing and balance at all times. This en-
ables better control of the power tool in
Dress properly. Do not wear loose
clothing or jewellery. Keep your hair
and clothing away from moving parts.
be caught in moving parts.
If devices are provided for the con-
nection of dust extraction and collec-
tion facilities, ensure these are con-
nected and properly used.
Use of dust collection can reduce
Do not allow yourself to get lulled into
a false sense of security and do not
ignore the safety regulations for pow-
er tools, even if you are familiar with
the power tool after repeated use. A
within a fraction of a second.
-
4. Power tool use and care
Do not force the power tool. Use the
correct power tool for your applica-
tion. The correct power tool will do the
it was designed.
Do not use the power tool if the
power tool that cannot be controlled
with the switch is dangerous and must
be repaired.
Disconnect the plug from the pow-
er source and/or remove the battery
pack, if detachable, from the power
tool before making any adjustments,
changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
Any
|
GB / IE