Turbo Mode - Parkside Performance Pptlba 40-Li C3 Originalbetriebsanleitung

NOTE
Observe noise protection and local reg-
►
ulations.
NOTE
Before switching the appliance on,
►
make sure that it is not in contact with
secure footing.
Press the ON/OFF button w to switch
♦
on the display.
To switch on the appliance, press the
♦
ON/OFF button w again.
To regulate the blowing power, press the
♦
button for the speed level q.
Press = one level higher
♦
Press = one level lower
♦
The 4 speed levels on the control panel in-
dicate which level the blowing power is at.
– Level 1
– Level 2
– Level 3
– Level 4
♦
ON/OFF button w.
Press and hold the ON/OFF button w
♦

Turbo mode

Press the TURBO button e to change
♦
the blowing power to turbo mode.
Press the TURBO button e again to end
♦
turbo mode. The blowing power then
changes to the previously set level.
9000 rpm
12500 rpm
15500 rpm
18000 rpm
Checking the charge level of the
battery
The charge level indicator 8 signals the
charge level of the battery packs 2 as long
as the appliance is switched on via the ON/
OFF button w on the control panel.
The charge level of the battery packs 2 is
indicated by the corresponding charge level
indicator 8 lighting up as follows.
Battery charged
Battery partially charged
Battery must be charged
If smart battery functions are supported,
the Ready2Connect LED 9 lights up in the
Connect the battery pack
Connect to the app
LED stays on
Not connected to the app
Tool in update mode
Tool update successful
Tool update failed
|
GB / IE