Fitting the blower pipe
Attach the blower pipe 4 to the motor
♦
housing 3 . The lock 7
Fitting the attachment
Slide the attachment 6 onto the blower
♦
pipe 4 . The knob o on the blower pipe
4 must engage in the guide rail 5 on
the attachment 6 .
There are 3 possible positions for the
attachment 6
♦
pipe 4 . The knob o on the blower pipe
4 must engage in the guide rail 5 on
u .
u
Removing the blower pipe
Press the lock 7 and remove the blower
♦
pipe 4 and attachment 6
Removing the attachment
Remove the attachment 6 from the
♦
blower pipe 4 by unthreading it from
the guide rail 5
♦
er pipe 4 by unthreading it from the
guide rail 5
Putting on the harness
Never wear the harness z diagonally
►
across your shoulder and chest. Only
ever wear it on one shoulder as this
allows you to quickly remove the appli-
ance from your body in case of danger.
Never use the appliance without the
►
harness z
ance before removing the harness z .
|
GB / IE
u onto the blower
u from the blow-
Never use several strap holders or sev-
►
eral shoulder straps at the same time.
►
tion, press both sides of the quick-re-
lease mechanism t to release the ap-
pliance from the harness z .
Place the harness z over one shoulder.
♦
♦
hook is about 10 cm below the hip.
Attach the snap hook of the harness z
♦
to the fastening lug i for attaching the
harness z .
This is located at the top of the appli-
Use
Before using the appliance, insert both
battery packs 2
harness z .
Wear suitable clothing and work
►
gloves when working with the appli-
ance. Ensure that the appliance is in
working order before each use. Make
sure that the appliance is assembled
aged, the appliance must no longer be
used. Personal protective equipment
and a fully functional appliance reduce
The turbine wheel continues to rotate
►
for some time after the appliance is
ing tools.
-
The harness z
comes with a
quick-release mecha-
nism t to quickly
detach the appliance
from the harness z in
a dangerous situation.
In a dangerous situa-
-
-