Environment Protection - Pcl App700Set Bedienungsanleitung

• DO NOT overreach. Always keep proper footing and balance. Ensure the floor is not slippery and
wear non-slip shoes.
• DO NOT use unauthorized parts and accessories, which may do harm to human body and
pneumatic tools.
• DO NOT use any liquids to clean the tool. Vacuum or dust with a clean rag will be sufficient.
• Keep the work area clean and well lit.
• Follow all workshop safety rules, regulations, and conditions when using the tool.
• The tool surface may become very hot after prolonged use. Avoid contact with the casing until it has
cooled.
• NEVER operate tools near flammable substances. Tools can cause sparks and should only be
operated in well-ventilated areas.
• Keep children and non-essential persons away from the working area.
• DO NOT carry the tool with your hand on the trigger to avoid unintentional starting.
• DO NOT use oxygen or any other combustible or bottled gas to power air-powered tools. Failure to
observe this warning can cause explosion and serious personal injury or death. Use only compressed
air to power the air-powered nibbler.
• Locate the compressor in a well-ventilated area for cooling and must be a minimum of 12" (31cm)
away from the nearest wall. Ensure the airline has a filtration device fitted.
• DO NOT use whilst using ladders or steps.
• When not in use, store in a safe, clean, dry, childproof place.
• WARNING! The warnings, cautions and instructions in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product but must be applied by the operator.
• Note: It is our policy to continually improve products and as such we reserve the right to alter data,
specifications and component parts without prior notice.
• Important: No Liability is accepted for incorrect use of this product.

2. ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging
should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the
environment. When the product becomes completely unserviceable and requires disposal, drain any fluids
(if applicable) into approved containers and dispose of the product and fluids according to local
regulations.
3. SPECIFICATIONS
Maximum Pressure:
Air consumption:
Air inlet:
Weight:
Vibration:
Minimum hose size:
Sound:
Collet Size:
Free Speed:
76629 Issue 1
90 psi (6.2 bar)
3 cfm (85 l/min)
1/4"
1.159 kg
3.15 m/s
3/8" (10 mm)
92 dBa
6 mm
20,000 rpm
www.pclairtechnology.com