Replacing The Aquaclean Filter; Measuring The Water Hardness - Saeco Incanto HD8919 Bedienungsanleitung

English

Replacing the AquaClean filter

80%
NEW?
1 / 8
WATER
FILTER
1 / 8
START
CALC
CLEAN

Measuring the water hardness

-
Then the machine ready screen appears with the AquaClean
icon to indicate that the filter has been installed.
Dispense cups of hot water
this water.
Replace the AquaClean filter when the filter icon starts flashing on the
display. Replace the AquaClean filter at least every
machine has not yet indicated that replacement is required.
Take out the AquaClean filter. 5ollow the steps in section 'Preparing and
installing the AquaClean filter'.
Press the MENU button, select MENU and press the OK button to
confirm. Scroll to 'AquaClean' filter. Press the OK button to confirm.
Dispense cups of hot water
this water.
Replacing the filter after
When the filter icon starts flashing on the display, press the MENU
button, select MENU and press OK to confirm. Scroll to 'AquaClean' filter.
Press OK to confirm.
-
The display tells you that you need to descale the machine before
activating the new filter.
Press the OK button to start the descaling procedure. See chapter
'Descaling procedure'.
-
Press the ESC button several times to leave the filter menu if you do
not want to descale right away.
At the end of the descaling procedure, the display asks you if you want
to install the AquaClean filter.
-
5ollow the steps in 'Replacing the AquaClean filter'.
To be able to adjust the machine settings to the water in your region, please
measure the water hardness with the water hardness strip supplied.
. l to complete the activation. Discard
months, even if the
. l to complete the activation. Discard
filters were used
%