Installation Requirements; Using The Filterbench; Before Start-Up; Service - Nederman Filterbench Bedienungsanleitung

8.1

Installation requirements

The FilterBench is easy to install and will provide satisfactory operation
subject to "good housekeeping".
The FilterBench is heavy. The unit must be installed on a level floor that
is able to take its weight. Before installation check that adequate space is
available for access, and the withdrawal of the filters.
9

Using the FilterBench

9.1

Before start-up

WARNING! Risk of injury.
Use proper protective equipment when risking exposure to the dust. Wear
a protective mask, googles and hand protection.
NOTE!
Before using the FilterBench this instruction should be read very
carefully.
Check the unit for any transport damage. After start-up of the fan, clogged
of filters should be checked. In case of clogged the filters-see chapter

"Maintenance".

9.2

Service

During operation the clogged of filters should be checked. In case of clogged
the filters - see chapter "Maintenance".
Speed of engine should be adjusted to type of work the fan.
10 Maintenance
WARNING! Risk of injury.
Use proper protective equipment when risking exposure to the dust. Wear a
protective mask, googles and hand protection
WARNING! Risk of injury, fire or explosion
Always isolate the mains power before changing filters or removing any
components from the FilterBench.
NOTE!
Before any kind of activity, the Chapter 4 - SAFETY must be read
carefully, and the safety regulations must be strictly adhered to.
Installation, repair and maintenance work is to be carried out by qualified
personnel using only original NEDERMAN spare parts. Contact your nearest
authorized distributor or NEDERMAN for advice on technical service.
NOTE!
The service intervals in this chapter are based on the unit being
professionally maintained.
If any deviations are made from the safety regulations, this may cause serious
personal injury. Before restarting, guards, hatches/doors etc. must be closed/
reestablished. The following elements are to be maintained regularly at the
FilterBench EN
QMM043(A) 59