Maintenance Intervals; Spare Parts; Disassembly; Troubleshooting - Nederman Filterbench Bedienungsanleitung

Maintenance intervals

In addition to maintenance intervals of clogged the filters, machinery doesn't
required other maintenance intervals.
10.2

Spare parts

Any repair and maintenance works must be carried out by qualified personnel
using only original NEDERMAN spare parts. Contact your nearest authorized
distributor or NEDERMAN for advice on technical service or if you require
help with spare parts. See also:
www.nederman.com
Ordering spare parts
When ordering spare parts always state the following:
• Serial number (see the product identification plate).
• Number and name of the spare part (see Table 10-1).
• Quantity of the parts required.
Only original parts supplied by NEDERMAN must be used to repair the
devices.
In the table below are listed the typical spare parts available.
Table 10-1: Spare parts for FilterBench
N°
1 Pre-Filter G4
2 HEPA Filter
3 Fan
NOTE.
Contact your nearest authorized distributor or NEDERMAN for
advice on technical service or if you require help with accessories. See also:
www.nederman.com
10.3

Disassembly

WARNING! Risk of injury.
Use necessary personal protective equipment.
During transport always use the right equipment.
11

Troubleshooting

All fault finding and fault correction activities may only be performed by
technically skilled and competent personnel with knowledge of the functions
and of the construction of the plant. Before restarting the plant, all screens,
doors, etc. must be restored.
Table 11-1 shows the possible causes of faults, as well as eliminate them.
Spare part name
FilterBench EN
Number Parts
12376528
12376529
12376530
QMM043(A) 61