Reset To Factory Settings - Laserliner Coatingtest-Master Bedienungsanleitung

Two-point calibration (cal 2)
11 Repeat steps 7-10
(„cal 2" and „zero y" appear on the display)
Complete one-point or two-point calibration:
Menu > Calibration > Disable > ESC
To increase the calibration accuracy, repeat steps 7-11 at least three to five
times using the same reference films that were used previously.
Performing measurement
12
DIR
100.0
AVG 100
NO 1
Zero

Reset to factory settings

13
The measurement device can be reset to the factory settings and the basic
calibration settings in order to delete all measured values, settings and
calibration values.
To do so, follow these steps:
28
EN
Fe
µm
1. Switch off measuring device
2. Press the keys „ON/OFF" and „ZERO"
at the same time.
3. Let go of the „ON/OFF" key and keep
„ZERO" pressed.
4. After starting, confirm the reset by responding
either „Yes" or „No" to the prompt.
Fe
DIR
100.0
µm
NO 1 AVG 100
Zero
!
During measure-
ment, keep the
device as straight,
tangential and still
as possible.