Korg Polysix Bedienungsanleitung Seite 22

3. To Recall a Stored Program:
Depress the desired BANK and PRO-
GRAM buttons. This cancels the Manual
mode (if selected).
Note:
it is not
always necessary to. depress two buttons
to change programs. If the new program
is located in the same bank as the current
one, simply depress the new PROGRAM
button. If going from program BS to D5,
just press the BANK D button.
Editing
The Polysix alsoallows the user to alter
any program either temporarily or perma-
nently via a powerful and easy to use
EDIT system. The user may:
The Polysix's Programmer is auto-
matically in EDIT
mode whenever a
program is selected.
The initial front
panel settings of the programmed
con-
trols and switches have no effect on the
sounds produced, which are determined
anly by the values stored in memory.
However,
changes made
to front panel
controls and switches after you select a
program will have an effect on the sounds
produced, The Edit system incorporates a
two
stage modification system
which
allows both small "incremental'" changes
and \arge alterations of program values.
4. To Change a Programmed Control
Setting:
Simply move the contro! in the desired
direction. The Programmer will recognize
the change and will make a corresponding
change to the actual value of that par-
ticular synthesizer function. This is called
Incremental Editing.
20
Thus, you may make as many changes
as you like to as many controls as you
like, even to the point of making a
program totally different from its original
state.
5. To Change a Programmed Switch Set-
ting:
Simply move the switch to the desired
position. Moving any switch causes the
Programmer to change that switch back
into its absolute state: the stored switch
setting is disregarded. (Note that it is
possible to move a switch with no ap-
parent change in sound occurring. This is
because that switch was moved into the
same position as was stored in memory.
Moving the switch again will cause the
sound to change accordingly.)
Move controls and switches as desired.
Each change will be reflected in the
sound heard, You can adjust and readjust
control settings in an unlimited manner in
this manner.
button. All temporary changes are erased,
8. To Make Changes Permanent:
To make changes permanent, you
Must execute a Write into memory se-
quence (see above for more details)
10. To Move an Altered Program to a
new location:
(3) When the program is altered as de-
sired, set WRITE ENABLE to 'the
"Enable" position.
buttons for the new location desired
(BANK button must be depressed
first). This moves the altered program
to the new location,
The program previously stored at that
location is erased. |f you want to keep
that program, you must first move it
to and Unused location. The original
version of the program you altered is
still in its original location,
i EE A