Remote Master Mode Settings - Metz mecablitz 52 AF-1 Canon digital Bedlenungsanleitung

10.1 Remote master mode settings

Slave groups A and B are always activated.
They cannot be deactivated. The master flash
unit and slave group C can be activated or
deactivated, however. If the master flash unit
is deactivated, it only controls the slave units
and does not contribute to exposing the
shot.
10.1.1 Remote master mode settings
• Switch on the flash unit with the
button. The start screen appears.
E TTL
• Press the sensor button of the displayed
-3,5 m mode of operation on the touch display as
0,3
many times as it takes for the display for
Z m
F4.0
35
OOM
m
selecting the mode of operation to appear.
EV
INFO
1
+ 1/3
• Press the
M
touch display and select
MASTER
SLAVE
• Press the
touch display. Remote master mode is set.
Remote master mode is shown in the picture.
REMOTE
E TTL
MASTER
The master itself has no influence on exposu-
OFF
re (REMOTE MASTER Off) and no lighting con-
RATIO Off
ditions (RATIO) are set.
INFO A+B+C
sensor buttons on the
MASTER
.
MASTER
sensor button on the
If the master is supposed to help with the
REMOTE
E TTL
MASTER
exposure, then:
• Press sensor button
RATIO Off
display for the flash mode until the selecti-
on for the master flash unit appears.
INFO A+B+C
MASTER
On / Off
• Press the
touch display.
MODE
EV
MASTER
• Press the
Off
display.
On
The setting is adopted immediately.
REMOTE
E TTL
MASTER
Remote master mode is shown in the picture.
The master emits a flash and contributes to
RATIO On
the exposure (REMOTE MASTER). No lighting
conditions (RATIO) are set.
INFO A+B+C
E TTL
on the touch
On / Off
sensor button on the
ON
sensor button on the touch
167
k