Metz mecablitz 52 AF-1 Canon digital Bedlenungsanleitung Seite 154

save energy and to protect the power source
from unintentional discharging. The active
automatic unit switch-off is shown in the
INFO display. The flash ready indicator
the indicators on the LC display disappear.
The
mode.
The most recently used operating setting is
retained after automatic shutdown and is
immediately restored when the camera is
switched on.
The flash unit can be turned on again by
pressing the
the shutter release (wake-up function).
+
In slave-/ servo mode, the automatic cut-off
is not activated.
The flash unit should always be turned off
k
using the main switch
to be used for an extended period.
If necessary, the Auto OFF function can be set
to occur after 1 minute of inactivity, or can be
deactivated.
The flash unit switches off completely about
1 hour after its last use.
154
D
button flashes red in stand-by
D
button, or by tapping on
if it is not going
and
m/ft
STANDBY
MOD.LIGHT
Off
Setting the automatic unit switch-off
• Switch on the flash unit with the
button. The start screen appears. The
flash unit always switches on afterwards
with the mode of operation that was used
last (e.g. manual flash mode M).
D
• Press the button as often as it takes
for the selection menu to appear.
OPTION
• Press the sensor button on the
touch display.
• Press the sensor buttons on the
touch display and select „STANDBY".
STANDBY
• Press the sensor button on the
touch display.
• Tap the sensor button on the touch display
for the desired time. The setting is adopted
immediately. The operation display appe-
ars after about 10 seconds, or press the
button repeatedly until the operation
display appears.
D
The button flashes red in stand-by
mode.
D