TROUBLESHOOTING
If an abnormality comes up, the induction hob will enter the protective state automatically
and display corresponding protective codes:
DISPLAY FAULT
No pot, or pot not suitable.
ER03
Water or pot on the glass over the control. Clean the user interface
The connection between the display
board and the left mainboard is fail (the
cooking zone which indicator
F1
showing
F3E
Coil temperature sensor failure. (the cook-
ing zone which indicator showing
F4E
Mainboard temperature sensor failure.
(the cooking zone which indicator
showing
E1E
Temperature sensor of the ceramic
glass plate is high.
E2E
Temperature sensor of the IGBT is high.
E3E
Abnormal supply voltage (too high).
E4E
Abnormal supply voltage (too low).
E5E
Temperature sensor failure(the cooking
zone which indicator showing
The above are the judgment and inspection of common failures. Please do not disassemble
the unit by yourself to avoid any dangers and damages to the induction hob and please
contact the supplier.
AFTER SALES CUSTOMER SERVICE
If your device needs to be repaired, please provide
Customer Service with the product type (SKU/XX)
and date of manufacture (PD). You will find these
on the rating plate located on the back of the de-
vice as shown in the figure on the right:
For quick finding, you can write your device details here.
SKU:
).
).
ACTION
Replace the pot
1. Connection cable not correctly plugged or
defective;
2. Replace the coil censor if connection
cable is ok
3. Replace the mainboard or power board if
coil sensor is ok
Replace the coil sensor
).
Replace the mainboard
Please restart after the hob cools down.
Please restart after the hob cools down.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Please inspect whether power supply is normal;
Power on after the power supply is normal.
Connection cable not correctly plugged or
assemble defective;
).
PYRAMIS METALLOURGIA
17th km Thessaloniki-Serres, Greece
SKU/XX / PD / Serial Number
Type
PD:
Voltage
Frequency
Power
23