Pyramis ROUND OCTA Installations-, Betriebs- Und Bedienungsanweisungen Seite 16

INSTALLATION
1. INSTRUCTIONS
1. The domestic appliance was built in order
to be encased on a work surface, the way
it is illustrated in the graph (image 1). Pre-
dispose sealing material (image 2) along
the whole perimeter. Lock the domestic
appliance into place with 4 clips, screw-
ing at the sides (image 3). If the lower
part of the appliance after installation, is
accessible via the lower part of the furni-
ture, it is necessary to mount a separat-
ing panel keeping in mind the distances
indicated (image 4A). Under any circum-
stances, make sure the Induction cooker
hob is well ventilated and the air inlet and
outlet are not blocked (image 4B).
2. Do not install refrigerators, dishwashers,
non-ventilated ovens or washing machi-
nes under the appliance.
3. The built-in kitchen units must withstand
temperatures of up to 90 °C.
4. A gap of at least 90mm must be allowed
between the hob and the side wall, where
applicable.
5. It is not recommended that the hob be
placed between two side walls but, if
this is the case, a gap of at least 200 mm
should be left on one side and a gap of
90mm on the other.
2. CONNECTING THE HOB TO THE MAINS
POWER SUPPLY
This hob must be connected to the mains
power supply only by a suitably qualified
person. Before connecting the hob to the
mains power supply, check that:
1. The domestic wiring system is suitable for
the power drawn by the hob.
16
2. The voltage corresponds to the value giv-
en in the rating plate
3. The power supply cable sections can with-
stand the load specified on the rating plate.
To connect the hob to the mains power
supply, do not use adapters, reducers, or
branching devices, as they can cause over-
heating and fire.
The power supply cable must not touch any
hot parts and must be positioned so that its
temperature will not exceed 75 ˚C at any point.
Check with an electrician whether the do-
mestic wiring system (image 5) is suitable
without alterations. Any alterations must only
be made by a qualified electrician.
• Power cord: Type H07 RN-F or higher, de-
terminate the required wire cross-section
depending on the current rating.
• If the cable is damaged or to be replaced,
the operation must be carried out the by
after-sale agent with dedicated tools to
avoid any accidents.
• If the appliance is being connected directly
to the mains an omnipolar circuit-breaker
must be installed with a minimum opening
of 3mm between contacts.
• The installer must ensure that the correct
electrical connection has been made and
that it is compliant with safety regulations.
• The cable must not be bent or com-
pressed.
• The cable must be checked regularly and
replaced by authorised technicians only.