Maintenance; Storage - Parkside Performance Ppmsa 20-Li A1 Bedienungsanleitung

2. Place the product with the front of
the base plate
[
the workpiece. The guide slots
indicate the cutting path.
3. Switch on the product (see "Switching
on/off").
4. Slowly push the product forwards. The
lower guard opens automatically.
[ ]
˜ Overload warning
If the product is in danger of being
damaged,
[ ]
product switches off.
˜ Cleaning, maintenance and

storage

WARNING! Risk of injury!
m
Protect yourself when performing
u
maintenance or cleaning work.
Switch off the product and remove
u
the battery pack
Have any repair and maintenance
o
work that is not described in these
instructions carried out by our Service
Centre (see "Service"). Only use
original replacement parts.
˜ Cleaning
WARNING! Risk of electric shock!
m
Never spray the product with water.
u
Do not immerse the product in water.
u
NOTICE! Risk of product damage!
m
Do not use cleaning agents or
u
solvents (except for the saw
blade , see following instruction).
[ ]
You may otherwise irreparably
damage the product.
22 GB
against the edge of
]
/
8 ] [ 9 ] [
lights up brie y. The
.
[ ]
Remove any dirt, such as resin, from
o
the saw blade
[
that do not impair the mechanical
properties of the saw blade.
Try to clean resinous surfaces with a
o
damp, lukewarm cloth that has been
wrung out well. Make sure that no
liquids can get into the interior of the
housing. Alternatively, you can use
a special cleaner (resin solvent) or
multispray. Heed the safety information
and instructions provided by the
manufacturer of the special cleaner/
multispray.
Keep the ventilation slots, motor
o
housing and handles clean. Use a
damp cloth or brush to do this.
Empty the upper guard
1. Remove the upper guard
„Removing/attaching the upper
guard").
2. Empty the upper guard
3. Re t the upper guard
„Removing/attaching the upper
guard").
˜ Maintenance
The product is maintenance free.
o
Before each use: Check the saw
o
blade for obvious defects. Replace
[ ]
the saw blade, if it is blunt, bent, or
damaged in any other way.
Have any maintenance work on the
o
saw blade (e.g. repair or regrinding)
[ ]
carried out by a professional.
˜ Storage
Always store the product and its
o
accessories
– clean,
– dry,
– protected against dust,
– in the storage case
– out of the reach of children.
using only solvents
]
(see
[ ]
( ig. G).
[ ]
(see
[ ]
,
[ ]