Parkside Performance PPMSA 20-LI A1 Bedienungsanleitung Seite 22

Control LEDs on the charger
Green Red
Lights —
up
— Lights
up
— Flashes
Flashes Flashes
˜ Attaching the parallel fence
( ig. D)
1. Loosen the wing screw
2. Slide the parallel fence
parallel fence support
screw must be able to grip the
[ 7 ]
parallel fence.
3. Set the desired width of the cut-off.
4. Tighten the wing screw
parallel fence
[
˜ Setting the cutting depth
1. Release the lock
upwards.
2. Set the desired cutting depth. The
marking points to the set cutting
[ ]
depth (can be read on the cutting
depth scale ) .
[ ]
3. ix the setting by pressing the lock
downwards.
˜ Removing/attaching the
upper guard
( ig. E)
NOTE
Switch off the product and remove
u
the battery pack
out any work.
20 GB
Meaning
Fully charged
Stand-by mode (no
battery pack
[ ]
inserted)
Charging
Battery pack is
[ ]
overheated
Battery pack is
[ ]
defective
.
[ 7 ]
into the
[ ]
. The wing
[ ]
to x the
7 ] [
in place.
]
by pushing it
[ ]
[
before carrying
[ ]
NOTE
Place the product on a table on the
u
edge of the table to make the work
step easier.
Removing the upper guard
1. Pull the lock
backwards. The lock is half open.
2. Pull the lock
backwards. The lock is open.
3. Remove the upper guard
sure to carefully remove the upper
guard from the bracket
Attaching the upper guard
Attach the upper guard
o
order.
˜ Mounting/changing the saw
blade
( ig. )
NOTE
Switch off the product and remove
u
the battery pack
out any work.
Place the product on a table on the
u
edge of the table to make the work
step easier.
1. Remove the upper guard
„Removing/attaching the upper
guard").
2. Press and hold the spindle lock
]
3. Loosen the bolt
key .
[ ]
4. Remove the bolt
washer .
[ ]
5. Carefully pull the lower guard
backwards with the protrusion
Keep the lower guard open.
6. Carefully pull the saw blade off the
spindle and remove it downwards.
[ ]
7. Carefully place the new saw blade
onto the spindle
on the left-hand side
[ ]
on the right-hand side
[ ]
. Make
[ ]
.
[ ]
in reverse
[ ]
before carrying
[ ]
(see
[ ]
6 ] [
with the hex
[ ]
and the
[ ]
[
[
from below.
[ ]
.
]
.
]
[ ]