Installing And Uninstalling; Basic Operation - Retevis Rt24 Bedienungsanleitung

ormal charging indicator
hen charging the battery, if the indicator light turns red, the battery is on the normal
harge; if the red indicator light blinks constantly, the battery capacity is too low, and is on
he trickling charge, and after the battery capacity reaches a certain level, it will switch to
he normal charge.
ote: Trickling charge does not exceed 30 minutes, if the red indicator light blinks after 30
minutes, it means the charger can not charge battery, please check whether the battery
or the charger has been damaged.
harging precautions:
) The battery is not fully charged in factory, please charge before using it.
) Charge and discharge the battery for two or three times, the battery capacity will reach
the best condition. When the battery capacity is low, please charge or change the batte
) The battery lasts shortly even if it is fully charged, the battery is exhausted, please
contact your local dealer to buy a new authentic Retevis battery.
Installing and uninstalling of the accessories
nstalling/Removing the battery
) Align the two grooves of battery and the guide rail on the back of aluminum shell,
ensuring full contact and in parallel, then push the battery up to the radio base along
the rail on the back of aluminum shell, until the battery latch locks up. (picture 1)
) To remove the battery, please make sure the radio is closed, push the battery latch
down, and make sure the radio and battery is on the releasing state, and then push
the battery out from the radio. (picture 2)
(picture 1)
041
(picture 2)
nstalling external headset
eveal (do not remove) the mic/speaker jack cover(picture 3) , insert the headset into the
ic/speaker jack (picture 4).
ote: IJsing the external headset will affect the water-tightness performance of radio.
RGTC7tS
(picture 3)

Basic operation

1. Scan Function
hen the radio is allowed to be scanned, which can be set by the software, you can press
he PTT key to turn on or turn off the scan. When the scan begins,indicators
he radio will can scan automatically from channel 1 to 16 which is defined as scan added.
hen there is signal in the scanning channel, it will stop in the channel for talk.
ote:
hen there is signal in the scanning channel, it will stop in the channel for a talk and after
everal seconds.
lease note that scan is only available when there are two or more than two memory
hannels and two or more scan added channels.
EG¯Ä
nercvts
(picture 4)
lights green,
105