Unpacking And Checking Equipments; Getting Familiar; Battery - Retevis Rt24 Bedienungsanleitung

Unpacking and checking equipment
Welcome to use two-way radio. Carefully unpack the radio. We recommend
you check the items listed in the following table before discarding the package.
If any item is missing, please contact local dealer immediately.
Supplied accessories:
Li-ion battery (1) Belt Clip (1)
Note: The antenna frequency range please refers to the annular label at the bottom of antenna.
Getting familiar
Antenna
Speaker
sound output
Microphone
Sound input
PTT switch
Press it to transmit,
release to receive
021
Charger (1) User's Manual (1)
Channel knob
Power/ volume knob
Indicator light
It turns red in transmitting,
and turns green in receiving.
It blinks red when the battery
capacity is low.
Mic/speaker jack/
programming port
Used to connect headset
or extemal programming
cable, programmable via
PC programming software
Li-ion battery
For supplying power to
radio

Battery

Please use Retevi5 designated battery; other batteries can cause explosion and hurt peopl
Notice: 1. Please do not short-circuit the battery terminals or expose of in fire. Do not dissemble
the battery by yourself.
2. Charge the battery between temperature O'C and 45'C. The battery can not be fully
charged beyond this temperature
3. Please turn off the power when you charge the radio with battery. Transmit with the
radio in charge will affect its correct charge.
4. Do not unplug the power or battery when it is charged.
5. The operating time becomes short even the battery is fully charged, the battery is
exhausted, please replace battery.
6. Please do not charge when the battery or the radio is wet. Please dry it with a cloth
before charging to avoid any danger.
arning: When the conductive metals such as jewelery, key or decorative chains touch the
battery terminals, all the batteries are likely to cause damage to the items or personal
injury. These conductive metals may form a short circuit and generates much heat.
Do deal with any battery carefully, especially when put it into pocket, wallet or other
metallic containers.
harging operations:
harge the battery as follows:
1) Power off
) Insert the DC adaptor plug in the DC jack on the back of charger
) Insert the AC adaptor plug in the AC power output socket
) Insert the battery or radio with battery vertically in a charger, to check whether the
battery and charger terminal is in normal contact.
) Make sure the battery and charger terminal is in good contact, when the charging
indicator light turns red, it starts charging.
Note: 1. Before inserting the battery, it is abnormal if the charging indicator blinks
2. To change the battery for charging, please wait until the indicator is stable.
3. When the battery is well inserted, the indicator tums red and the charging is on the
process, if the indicator blinks, then the battery is damaged or the temperature is too
high or too low.
elf-testing
hen the charger powers up, if the orange indicator lights for one second and then goes
ut, entering the standby mode, the charger passes the self-testing and can charge the
attery. If the orange indicator blinks constantly, the charger fails to pass the self-testing,
nd can not char e the batte
range.
103