Retevis RT24 Bedienungsanleitung Seite 6

alkie talkie PC programming operation process
System Requirements
perating System :Windows98, Windows Me, Windows XP, Windows Vista, Windows7,
indows8
ard Disk Space: At least 50MB of available .
he minimum memory: 64M
l. Install the programming cable driver
. Find the write line drive which your system corresponded to
Click to install, successfully installation is 0k
installed, and open the programming software programming interface
II. Programming software installation
rogramming cable readying
• USB Programming cable - need to install the driver before they PC programming
e Serial port Programming cabletdoes not need to install thetdriver'it
omputer terminal preparations
• Open the computer, run the computer operating system.
e Install the wprogramming software which has been downloaded well or Install it From
the programming software CD
alkie Talkie end preparations
• USB(or serial)Programming cable connect the computer end
e The USB Programming cable pin is connected with one end of the walkie talkie progra-
mming interface
e Ensure the walkie talkie under the condition of power, open it.
V. Programming software operating process
Find the software settings, open communication
Option and computer connection port consistent (inconsistent will not read frequency) to
solve the related problem
In the menu to find reading frequency and click in the window that appears can reading
frequency
This process needs waitting for a while, after the completion of reading the progress bar
shows the walkie talkie channels and frequencies that have been read into the current
software
Modify the walkie talkie channel and frequency data, and other functional parameter dat
. Find the PC programming in the menu ,click the appeared window to confirm , complet
the progress bare
can directly write
port, to ensure the communication port
if multiple walkie talkie needs the same frequency, frequency steps can be repeated to
write
Related problem solving
hen reading or PC programming of walkie talkie long time no response or a communica-
ion error?
check the programming cable to find if it is damaged
check whether the programming cable with computer serial port or walkie talkie interface
is bad or loose
Check to find whether the walkie talkie battery is low or out of power , if this, please rep
lace the battery or charging the battery
Check whether the programming software is match with the current model
Please check whether the programming software port settings are assigned to the
computer USB port
Please check whether the power is switched on the walkie talkie
Whether to choose the corresponding drive system and the correct installation
When PC programming is completed, found two walkie talkie cannot normal call or
receive
Make sure whether the two walkie-talkie
Determine the same channel at the receiving end CTCSS, CDS and the transmitter is
not the same
make sure whether the two walkie talkie' volume is too low, if it is too low , Turn up the
volume
Please check whether the two walkie-talkies are open, or at low/no power status
Check wether the walkie-talkie installed
check and confirm wether the communication
are in the same channel
antenna
distance is too far
109