Scheppach 5903822901 Originalbetriebsanleitung Seite 25

7. Before commissioning
• Open the packaging and carefully remove the device.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
m ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
• The brushing roller must be able to run freely.
• Before pressing the on/off switch, make sure that
the brushing roller is correctly fitted and that moving
parts run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
Connection to the mains
Check whether the network to which you connect the
machine is properly earthed according to the valid
standards and whether the outlet is in good condition.
8. Assembly
m WARNING! Electric shock
Unplug the mains plug from the socket before carrying
out any work on the machine!
Installing the front handle (fig. C)
1. Screw the front handle (1) into the attachment
point on the device and tighten it.
Adjusting the protective cover (Fig. A+B)
Adjust the protective cover (11) so that dust or sparks
are not directed towards the operator.
1. Loosen the clamping screw (12) using the Allen
key (17).
2. Turn the protective cover (11) to the desired po-
sition.
3. Retighten the clamping screw (12) using the Allen
key (17).
Fitting/replacing the brushing roller (Fig. A + C)
1. Release the fixing screw (7) and fold the cover (5)
to the side.
2. Slide the wide brush roller (6) or the narrow brush
roller (16) onto the mounting shaft (13).
3. Actuate the shaft interlock (8) and fit the clamp-
ing nut (15) with the spring washer (14). Use the
clamping spanner (18) for this.
4. Close the cover (5) and secure it with the fixing
screw (7).
5. Disassembly takes place in reverse order.
9. Commissioning
m Attention!
Always make sure the device is fully assembled before
commissioning!
Selection of the brushing roller
Depending on the application and the material to be
processed, different brushing rollers are available (not
necessarily included in the scope of delivery).
Only use manufacturer's recommended original brush-
ing rollers.
Brushing rollers can be obtained from your dealer.
Switching on/off (fig. A)
m ATTENTION! Always guide the device with both
hands.
m ATTENTION! First, switch the device on and wait
until the brushing roller (6 / 16) has reach maximum
speed before starting work on the workpiece.
1. Always hold the device with one hand on the front
handle (1) and the other on the rear handle (3).
2. Switching on: Slide the on/off switch (2) forwards
so that it locks.
3. Switching off: Release the on/off switch (2) and
wait until the brushing roller (6 / 16) comes to a full
stand still before putting the device down.
Setting the speed (Fig. A)
1. Use a speed adapted to the application in order to
prevent damage to the material.
2. Select the desired speed for the speed preselec-
tion (4) using the setting wheel.
3. The required speed is dependent on the material
and the working conditions and can be determined
with a practical trial.
www.scheppach.com GB | 25