EN
7
TROUBLESHOOTING
PROBLEM
The motor does not start when you
pull the trigger.
Run-time is too short.
The product releases smoke during
operation.
The motor is on, but the blades do
not move.
Excessive noise and/ or vibration
during operation.
8
TECHNICAL DATA
Voltage
Blade speed
Blade length
Cutting capacity
Measuered sound pressure level
Guaranteed sound power level
Vibration
Uncertainty
Battery model
Charger model
English
POSSIBLE CAUSE
The battery is not installed correctly.
The battery is depleted.
There is dirt or debris in the battery
connectors.
Normal battery life has been excee-
ded.
Battery not fully charged.
Too much friction, due to lack of lubri-
cant spray.
The edge of the blade is worn.
The product has sustained damage.
The product has sustained damage.
The blades are jammed.
The screws and nuts are not properly
tightened.
Dry or corroded blades.
Blade or blade support is bent.
Bent or damaged teeth.
24V
4000 (±10%) SPM
610 mm
28 mm
86 dB(A), K
=3 dB(A)
PA
97 dB(A)
2
6.3 m/s
2
1.5 m/s
G24B2, G24B4 and other BAG series
G24C, G24UC2, G24X2UC2, G24X2UC4 and other CAG series
8
POSSIBLE ACTION
Make sure that you correctly install
the battery in the product.
Charge the battery.
Clean the battery connectors with
compressed air or a soft brush.
Charge or replace the battery.
Apply lubricant spray.
Sharpen the blade regularly.
1. Immediately stop the product.
2. Remove the battery.
3. Consult your nearest service cen-
ter.
Do not use the product. Consult your
nearest service center.
Remove battery, clear obstruction
from the blades, then reinsert the
battery and restart the product.
1. Stop the product.
2. Remove the battery.
3. Inspect for damage.
4. Inspect and tighten loose screws
and nuts.
Lubricate the blades.
Replace with a new blade or blade
support. Consult your nearest service
center.