1. In-built Condenser Microphone
2. Indicator Light Guide
Device Status
Unpaired
Pairing
Successfully paired
Disconnected (out of range)
Reconnected (within range)
Noise reduction enabled
Low battery
Charging
Fully charged
Notes:
The transmitter will automatically power off after 10 minutes if left unpaired.
•
If multiple features are active, the indicator light will only show one status at a
•
time. Priority is as follows:
Pairing > Low Battery > Reconnecting > Noise Reduction
3. Power Button Functions
Operation
Press and hold for 2 seconds
Press once
Press and hold for 5 seconds (when off)
Notes:
The transmitter automatically powers on when removed from the charging case,
•
and powers off when placed back inside.
Noise reduction is disabled by default. It cannot be toggled while the transmitter
•
is reconnecting to a receiver.
4. Charging Contacts
5. Belt Clip
Indicator Light
Blinking blue
Rapid blinking blue (for 5 minutes)
Solid blue
Blinking blue
Solid blue
Solid green
Blinking red (once per second)
Solid red
Red light turns off
Description
Turn the transmitter on or off
Enable or disable noise reduction
Enter pairing mode
5