Troubleshooting - Genius Invictus X4 Gebrauchsanleitung

8. Insert the pre-motor filter into the multi-cyclone filter. Ensure correct positioning.
9. Insert the HEPA filter into the multi-cyclone filter and turn it clockwise to tighten.
10. Replace the filter in the hand-held appliance. Ensure it is correctly positioned. The opening must point in the
direction of the motor housing.
Cleaning the brush rollers
1. To remove the brush roller, release the lock and pull the brush roller out sideways. The brush cannot be separated
from the plastic cover.
2. Wipe the brush roller or clean it under running water if necessary. Cut off tangled hair with the small knife
(see Fig. I).
3. Allow the brush roller to dry completely.
4. Push the brush roller back into the housing and snap the cover into place.

Troubleshooting

Only for electrical appliances
WARNING!
Switch off the appliance and disconnect the mains plug before addressing any faults! Failure to do so may result in
injury or electric shock.
Problem
Appliance isn't working. Battery is empty.
Battery will not charge. Appliance or charging station is
Suction power
decreases.
Instruction manual
Possible causes
Brush roller is blocked.
not correctly connected to a
power socket.
Contact with charging station
has not been established.
Suction opening on the container
is blocked.
Dust container is full.
Filters are dirty.
Brush roller is blocked.
Solution
Charge the battery.
Clean the brush roller and remove debris such as hair
and fibres if necessary.
Connect the mains adaptor correctly to a functioning
power socket.
Position the hand-held appliance correctly in the
charging station.
Clean the suction opening on the hand-held appliance
and check the suction tube for any dirt.
Empty the dust container.
Clean the filters, replace the HEPA filter if necessary.
Clean the brush roller and remove debris such as hair
and fibres if necessary.
GB
25