Cleaning The Filter; Troubleshooting - Genius Invictus C9 Gebrauchsanleitung

3. Remove the collected dirt and clean the container with lukewarm water if necessary.
4. Allow the dust container to dry completely before reinserting it into the device.

Cleaning the filter

1. Clean all filters regularly to maintain the vacuum's functionality.
2. Remove the cover.
3. Remove the mesh filter on the underside of the cover by turning it anti-clockwise (see fig. F).
4. Remove the fabric and sponge filters from the main device (see fig. G).
5. Clean the filters under running water and allow them to dry completely.
6. Replace all filters in the device correctly.
Cleaning the accessories
1. Remove any dirt adhered to the accessories and the hose.
2. Rinse the parts under running water if necessary.
3. Allow all parts to dry completely before using them again.
NOTE!
Allow the filters to dry COMPLETELY before refitting them, otherwise you may damage the appliance.

Troubleshooting

WARNING!
RISK OF ELECTRIC SHOCK
Switch off the appliance and disconnect the mains plug before addressing any faults!
„
Do not use the appliance if:
„
• The power cable is damaged.
• Liquid has been absorbed and has penetrated the inside of the device.
• The device has been dropped.
In these cases, the electrical safety of the appliance may no longer be guaranteed, even if no external damage
„
is recognisable.
Problem
Appliance isn't working.
Suction power decreases.
NOTE!
If the fault cannot be rectified, please contact our customer service. Never open up the appliance!
Instruction manual
Possible cause / solution
Check whether the appliance is connected to a functioning socket.
It may be that the socket is defective, try a different one.
Clean the filter.
Check whether dirt has collected in the suction pipe, the floor nozzle or in the suction
opening. Remove this if necessary.
GB
19