Cutting Height Adjustment - Stiga Scm 240 R Gebrauchsanweisung

Position the trim (1) where the extensions and the
bottom part of the handle (2) meet. Press on the
trim gently until it is securely fitted in place. No
screws required.

CUTTING HEIGHT ADJUSTMENT

(see figure 6)
1.1 Model SCM 440 FS
Adjust the height by moving the lever (1) to one
of the 9 positions.
1.2 Model SCM 240 R
Slacken the knob (2), move the roller (3) to
achieve the required height and then tighten the
knob.
Carry out the same adjustment on both sides to
achieve uniform cutting height.
Further cutting positions can be achieved by
moving the handle (2) to the holes 4 and 5.
3 GRASS CUTTING
NOTE This machine can be used to mow
lawns in a number of different ways; before start-
ing work, prepare the machine based on how the
lawn is to be mowed.
Install the sack (if purchased).
3.1 Grass cutting
The grass will look better if cutting is always car-
ried out at the same height and working alternate-
ly in the two directions.
Empty the grass collection sack when it is full.
Lawn care recommendations
Each type of grass has different characteristics
and may thus require different ways of caring for
the lawn; always read the instructions on seed
boxes for mowing height for the growing condi-
tions in the work area.
Keep in mind that most grass is made up of a
stem and one or more leaves. If leaves are ful-
ly cut, the lawn is damaged and growth is more
difficult.
The following indications generally apply:
– cutting too low tears and uproots the grass, giv-
ing it a "spotted" appearance;
– in the summer, cutting must be higher to pre-
vent the ground from drying;
– do not cut wet grass; this could reduce cutting
means efficiency due to sticky grass and tear
the lawn.
– for particularly high grass, initially mow at the
maximum height allowed by the machine then
mow again after two or three days.
4. ROUTINE MAINTENANCE
Store the lawnmower in a dry place.
IMPORTANT
nance is essential in maintaining original machine
safety and performance levels.
1) Wear sturdy work gloves when carrying out
cleaning operations;
2) Wash the machine thoroughly with water af-
ter each use;
3) immediately touch up any damaged paintwork
with anti-rust paint to stop rust forming which
could corrode the metal work..
4.1 Cutting means maintenance
Adjustment and sharpening of the cutting-means
assembly must be carried out at a specialised
centre which has the right equipment.
If you are not going to use your mower for a pro-
longed period of time, grease the cutting-means
assembly adequately.
6. DIAGNOSTICS
PROBLEM
The grass is not cut neatly.
Grass is ripped up or is
difficult to cut.
In the event of any doubts or problems, please
do not hesitate to contact you nearest Technical
Assistance Service or Dealer.
EN - 4
Routine and accurate mainte-
REMEDY
Adjust the cutting-means
device.
Sharpen or replace the
cutting-means assembly.