System Message Update - Dell PowerEdge 2950 serie Handbuch

If you are using the TPM with an encryption application, you are prompted
to create a recovery key during system setup. Be sure to store this recovery key.
If you replace the system board, you must supply the recovery key when you
restart your system before you can access the encrypted files on your hard
drive(s).

System Message Update

Table 1-1 lists new system messages for the PowerEdge 2950 III system and
the probable cause and corrective action when the message appears. System
messages appear on the screen to notify you of a possible problem with the
system.
WARNING:
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
Table 1-1. System Messages
Message
Alert! Node
Interleaving
disabled! Memory
configuration does
not support Node
Interleaving.
10
Information Update
Only trained service technicians are authorized to remove the system
Causes
The memory configuration
does not support node
interleaving, or the
configuration has changed
(for example, a failed
DIMM) so that node
interleaving cannot be
supported. The system
runs but with reduced
functionality.
Corrective Actions
Ensure that the memory
modules are installed in a
configuration that supports
node interleaving. Check
other system messages
for additional information
for possible causes.
For memory configuration
information, see
"General Memory Module
Installation Guidelines"
in the Hardware Owner's
Manual. If the problem
persists, see "Trouble-
shooting System Memory"
in the Hardware Owner's
Manual.