System Message Update - Dell PowerEdge 2900 serie Handbuch

System Message Update

Table 1-1 lists new system messages for the PowerEdge 2900 III system
and the probable cause and corrective action if the message appears.
CAUTION:
cover and access any of the components inside the system. See your Product
Information Guide for complete information about safety precautions,
working inside the computer, and protecting against electrostatic discharge
Table 1-1. System Messages
Message
Alert! Node
Interleaving
disabled! Memory
configuration does
not support Node
Interleaving.
!!*** Error: Remote
Access Controller
initialization
failure *** RAC
virtual USB devices
may not be
available...
Invalid PCIe
card found in the
Internal_Storage
slot!
10
Information Update
Only trained service technicians are authorized to remove the system
Causes
The memory configuration
does not support node
interleaving, or the
configuration has changed
(for example, a failed
DIMM) so that node
interleaving cannot be
supported. The system
runs but with reduced
functionality.
Remote Access Controller
initialization failure
The system halted because
an invalid PCIe expansion
card is installed in the
dedicated storage controller
slot.
Corrective Actions
Ensure that the memory
modules are installed in a
configuration that supports
node interleaving. Check
other system messages
for additional information
for possible causes.
For memory configuration
information, see
"General Memory Module
Installation Guidelines"
in the Hardware Owner's
Manual. If the problem
persists, see
"Troubleshooting System
Memory" in the Hardware
Owner's Manual.
Ensure that the Remote
Access Controller is
properly installed. See
"Installing a RAC Card"
in the Hardware Owner's
Manual.
Remove the PCIe expansion
card and install the internal
SAS controller in the
dedicated slot.