Dell PowerEdge 2950 serie Handbuch Seite 14

Table 1-1. System Messages (continued)
Message
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
Warning! No micro
code update loaded
for processor n
Warning: The
installed memory
configuration
is not optimal.
For more
information on
valid memory
configurations,
please see
the system
documentation
on the technical
support web site.
Write fault
Write fault on
selected drive
14
Information Update
Causes
A fatal system error
occurred and caused the
system to restart.
Micro code update failed.
Invalid memory
configuration. The system
runs but with reduced
functionality.
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or
hard-drive subsystem.
Corrective Actions
Check the SEL for
information that was
logged during the error.
See the applicable
troubleshooting section
in See "Troubleshooting
Your System" in the
Hardware Owner's Manual.
for any faulty components
specified in the SEL.
Update the BIOS firmware.
See "Getting Help" in the
Hardware Owner's Manual.
Ensure that the memory
modules are installed in
a valid configuration. See
"General Memory Module
Installation Guidelines"
in the Hardware Owner's
Manual. If the problem
persists, see
"Troubleshooting System
Memory" in the Hardware
Owner's Manual.
Replace the faulty media.
Reseat the USB device or
USB cable. For hard drive
problems, see
"Troubleshooting a Hard
Drive" in the Hardware
Owner's Manual.